на некоторых иномарках блок управления SRS одноразовый, там стоит датчик и срабатывает при ударе, какой в сиде блок не знаю
Вот из сервис-мануала: "Once airbag is deployed, SRSCM should not be used again but replaced."
SRSCM это SRS CONTROL MODULE.
------------------------------------------------------------------
COMPONENT REPLACEMENT AFTER DEPLOYMENT
Before doing any SRS repairs, use the Hi-Scan Pro to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs.
When the front airbag(s) deployed after a collision, replace the following items.
– SRSCM
– Deployed airbag(s)
– Seat belt pretensioner(s)
– Front impact sensors
– SRS wiring harnesses
– Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
When the seat belt pretensioner(s) deployed after a collision, replace the following items.
– Seat belt pretensioner(s)
– SRSCM (if B1658 detected)
– Front impact sensors
– SRS wiring harnesses
When the side/curtain airbag(s) deployed after a collision, replace the following items.
– SRSCM
– Deployed airbag(s)
– Side impact sensor(s) for the deployed side(s)
– SRS wiring harnesses
After the vehicle is completely repaired, confirm the SRS airbag system is OK.
– Turn the ignition switch ON, the SRS indicator should come on for about 6 seconds and then go off.